Subversion Repositories HomeAutomation

## Section act_softPWM -- Do not edit this line

#Uncomment the line below if you want to use EEPROM with this module, dont forget to also uncomment the line in sources.list
act_softPWM_USEEEPROM=1

act_softPWM_ID=<ID>
#act_softPWM_DUMMY=1
act_softPWM_TIMER=<TIMER>
act_softPWM_SEND_TIMER=<TIMER>

# set this to the number sent messages from this module
# that must be sent without any update to the pwm value
# before the output shall turn off.
# set it to 0 to deactivate this feature
act_softPWM_ACTIVATE_AUTOOFF=0

#use up to 8 channels, but do it in order, otherwice there will be problems setting the correct values over CAN
# set INVERT to 1 to invert pwm output
act_softPWM_PIN_0 = EXP_C
act_softPWM_PIN_0_INVERT = 0
act_softPWM_PIN_1 = EXP_E
act_softPWM_PIN_1_INVERT = 0
act_softPWM_PIN_2 = EXP_H
act_softPWM_PIN_2_INVERT = 0
#act_softPWM_PIN_3 = EXP_xx
act_softPWM_PIN_3_INVERT = 0
#act_softPWM_PIN_4 = EXP_xx
act_softPWM_PIN_4_INVERT = 0
#act_softPWM_PIN_5 = EXP_xx
act_softPWM_PIN_5_INVERT = 0
#act_softPWM_PIN_6 = EXP_xx
act_softPWM_PIN_6_INVERT = 0
#act_softPWM_PIN_7 = EXP_xx
act_softPWM_PIN_7_INVERT = 0



#the maximum of supported channels, must be set to x+1 when the highest PIN is PIN_x
NUMBEROFCHANNELS = 3

#Uncomment to use the pcint driver
#act_softPWM_DUMMY_PCINT=<PCINT>

## End section act_softPWM -- Do not edit this line