Subversion Repositories HomeAutomation

## Section sns_Serial -- Do not edit this line

#Uncomment the line below if you want to use EEPROM with this module, dont forget to also uncomment the line in sources.list
#sns_Serial_USEEEPROM=1

sns_Serial_ID=<ID>
#sns_Serial_DUMMY=1
#sns_Serial_DUMMY_TIMER=<TIMER>

#Uncomment to use the pcint driver
#sns_Serial_DUMMY_PCINT=<PCINT>

# Configuration based on RS232/RS485-driver LTC1387

#port for hw flow control, clear to send
sns_Serial_CTS=GPIO_D2
#port for hw flow control, request to send
sns_Serial_RTS=GPIO_D4
#port for ON
#high ON enables charge pump, low ON enables loopback mode
sns_Serial_ON=GPIO_D5
#port for enable receive
#high RXEN enables receive
sns_Serial_RXEN=GPIO_D6
#port for enable transmit
#high TXEN enables transmit
sns_Serial_TXEN=GPIO_D7
#port for choosing RS485 or RS232
#high is RS485, low is RS232
sns_Serial_485_232=GPIO_B0
#port for external (DSUB-connector) LED
sns_Serial_EXT_LED=GPIO_B1
#port for external (DSUB-connector) switch
sns_Serial_EXT_SWITCH=GPIO_C0
#port for joining RS485 transmit and receive, full vs half duplex
sns_Serial_485_CONNECT=GPIO_C4
#port for enabling termination resistor
#when used mode should be 485 and half duplex
sns_Serial_TERM_EN=GPIO_C5

## End section sns_Serial -- Do not edit this line